VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2020-02-11 14:39:36

rs4
Member
Registered: 2009-11-15
Posts: 2

Siemens Sinumerik 840D G02 G03 circular interpolation error

Good morning

Siemens 840D the vericut I can't read the following interpolation "I and J" cyclic G02 G03, what are the parameters to be set and in which file ??

Signaling: Incorrect circular interpolation. r1 = 0.999914, r2 = 0.999831

block example:G02 X56.574 Y-236.346 I = AC (56.32547) J = AC (-235.37755)

thank you

Last edited by rs4 (2020-02-11 15:22:14)

Offline

#2 2020-02-13 13:33:56

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 176
Website

Re: Siemens Sinumerik 840D G02 G03 circular interpolation error

Go to Control Settings > General > increase the Calculation Tolerance slightly


Tony

Offline

#3 2020-02-13 14:05:33

rs4
Member
Registered: 2009-11-15
Posts: 2

Re: Siemens Sinumerik 840D G02 G03 circular interpolation error

Thanks Tony

Now it works you were very kind, I set 0.0254mm as the value.

Last edited by rs4 (2020-02-13 14:05:52)

Offline

#4 2020-02-13 14:50:06

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 176
Website

Re: Siemens Sinumerik 840D G02 G03 circular interpolation error

0.0254 is fine.


Tony

Offline

Board footer