VERICUT Users' Forum

kathy

Member

Registered: 2004-12-10

Posts: 6

Website

Unclamped Stock question

I have a Vericut user file I last modified in Sept 2005. At that time, everything in the file ran fine (that I can recall). In addition, I have 4 other user files with similar hardware setup the same exact way.

This afternoon I need to check something in my one file. The stock disappears with the message ?Cut Stock was unclamped and is temporarily saved in Unclamped Stock?. I compared all five component trees, before and after and can?t figure out what setting changed.

By the way, the four other files run just fine.

I have never had to deal with ?unclamped stock? before. ~Kathy

GavinP

VERICUT Specialist

From: UK

Registered: 2004-10-14

Posts: 58

Website

Re: Unclamped Stock question

Is Model, Delete Material, Update While Simulating checked ?

If it is uncheck and run again.

kathy

Member

Registered: 2004-12-10

Posts: 6

Website

Re: Unclamped Stock question

Gavin -

Thank you! That was the problem. And now I can get 'Delete, Material' to work.

I'm a happy camper...

~Kathy