VERICUT Users' Forum

WCooper

Member

From: Charlotte

Registered: 2023-06-16

Posts: 6

Speed of Simulation Play Slower Settings

Hi-
A 100 percent accurate to real life tool movement speed, including toolchange movement speed would be nice. The current slowest settings are still fairly fast and single block only conveys a certain amount of detail.

Tony

Moderator

From: Crewe, England

Registered: 2007-02-20

Posts: 181

Website

Re: Speed of Simulation Play Slower Settings

If your simulation is too fast change the Min Motion Dist to 0.01 and the Max Motion Dist to 0.1, now when you move the slider off 100% it should be slower.

If you want to go even slower, make these values smaller.

Tip, if you want to see something in a single block, repeatedly tap the + key or keep it held down.

---

Tony

AClements

Member

Registered: 2022-06-23

Posts: 1

Re: Speed of Simulation Play Slower Settings

Hi Tony

what's the largest Max Motion Dist I can use? currently at 10 but it runs very slow looking to speed things up if i can.

TIA

Tony

Moderator

From: Crewe, England

Registered: 2007-02-20

Posts: 181

Website

Re: Speed of Simulation Play Slower Settings

I dont think there is a limit, but results will vary depending on what you are doing.

---

Tony