VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2005-07-28 03:49:47
- yangyh
- Member
- From: Peoria IL
- Registered: 2005-03-13
- Posts: 6
The CYCLE command in Siemens840D control
Dear all,
Here is the cycle command in the program.
CYCLE85(180,175,1,,123.6,0.5,291,291)
How can I interpret all the parameters? The explaination of Word/Address
can be refered in the attached picture. Thanks.
David
Caterpillar Inc.
Offline
#2 2005-08-02 15:26:15
- yangyh
- Member
- From: Peoria IL
- Registered: 2005-03-13
- Posts: 6
Re: The CYCLE command in Siemens840D control
Offline
#3 2005-08-04 13:44:41
- Dolf
- Member
- From: EDE, The Netherlands
- Registered: 2005-01-09
- Posts: 15
Re: The CYCLE command in Siemens840D control
Hi,
Here you can find the manuals of Siemens 840D with an explanation
of the parammeters.
http://www.automation.siemens.com/doconweb/
Succes, Dolf
Offline
#4 2005-10-10 19:40:23
- prayasam
- Guest
Re: The CYCLE command in Siemens840D control
I guess you would've already figured out the working of cycles inside Vericut by now.
If not, did you try adjusting the settings through Setup>Control>Settings>Cycles?
There is also some documentation regarding the interpretation of cycles inside vericut. (Control Settings, Cycle tab).
Prasad Rayasam
Ingersoll Machine Tools