You are not logged in.
Pages: 1
The ability to 'shake off' excess stock.
Sometimes when I profile, I will create a radius from within a square piece of material. As such after I have finished simulation. I'm left with the excess in the corners. Thats fine until I want to take the cut stock to the next op. I'm stuck with these corners which show tool rapid collisions on Vericut, yet I know the material is not there.
It can also happen with Turning when we part off. We are left with excess materail in mid air. As such we usually define a tool tip 6 feet wide just to cut off the excess.
A button when your finished simulation to shake off the excess would be nice.
M74UK
Offline
Will the delete material under the model menu do want you need?
Kantha
Offline
Yes..............a bit like that.
Thanks :oops:
Offline
Pages: 1