VERICUT Users' Forum

Mitch_vc

Member

Registered: 2015-07-09

Posts: 12

VERICUT Reviewer - NC Program (NC Program Listing Area)

We started using VERICUT Reviewer, and everything works for about week, and now I can't open NC Program (NC Program Listing Area).
Everything else works.

VERICUT Reviewer 7.3.1 on one computer and VERICUT Reviewer 7.3.3 on second computer.
VERICUT 7.3.1 (64)
Windows 7 (64)

Vericut_McAtee

Senior Member

From: Fryeburg, Me.

Registered: 2011-07-17

Posts: 88

Re: VERICUT Reviewer - NC Program (NC Program Listing Area)

Hi,
The Reviewer is version dependent. So if a job was saved with version 1 it must be played with version 1. It is not compatible with a later version or a newer version.
☺

Mitch_vc

Member

Registered: 2015-07-09

Posts: 12

Re: VERICUT Reviewer - NC Program (NC Program Listing Area)

I have same version 7.3.1(64) VERICUT and 7.3.1(64) VERICUT Reviewer on my computer, still can't open NC Program Listing Area.

rdix33

Senior Member

Registered: 2005-03-21

Posts: 37

Re: VERICUT Reviewer - NC Program (NC Program Listing Area)

If the Program moved or was renamed from the original area it was located it will not open.

Mitch_vc

Member

Registered: 2015-07-09

Posts: 12

Re: VERICUT Reviewer - NC Program (NC Program Listing Area)

Hi,

Program was not moved, and wasn't renamed.

I think this disappearance, has something to do with preferences - PDF/HTML/EDITOR,
because I played with preferences. After that I was able to open NC Program Listing.
But, I'm not sure about that.

Anyway, Thank You VERICUT Reviewer is working now, and we are using.

Mitch

Mitch_vc

Member

Registered: 2015-07-09

Posts: 12

Re: VERICUT Reviewer - NC Program (NC Program Listing Area)

Problems with VericutReviewer 7.3.3
1. Take long time to save VC reviewer file.
2. When I check, Check Box "Replace Material When Stepping Back" in File - Properties, and reopen VERICUT  the Check Box is uncheck.
Mitch