VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2014-03-27 14:25:56

Verifun
Senior Member
From: U.S.
Registered: 2005-03-31
Posts: 351
Website

Move cutter compensation value to leftmost position in Tool Manager

Hi folks,

I'll ask my local support team to open an SCR for this:

Move cutter compensation value to leftmost position in Tool Manager


Daniel Santos

Offline

#2 2014-03-27 15:16:40

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 128
Website

Re: Move cutter compensation value to leftmost position in Tool Manager

Nice one, makes it easier to read


Tony

Offline

#3 2014-03-28 15:14:33

Verifun
Senior Member
From: U.S.
Registered: 2005-03-31
Posts: 351
Website

Re: Move cutter compensation value to leftmost position in Tool Manager

We have a SCR now: SCR #12283 -- Move cutter compensation value to leftmost position in Tool Manager


Daniel Santos

Offline

#4 2014-03-31 07:28:01

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 128
Website

Re: Move cutter compensation value to leftmost position in Tool Manager

Cutter Comp values are now aligned to the left


Tony

Offline

#5 2014-03-31 18:43:41

Verifun
Senior Member
From: U.S.
Registered: 2005-03-31
Posts: 351
Website

Re: Move cutter compensation value to leftmost position in Tool Manager

big_smile big_smile big_smile

Last edited by Verifun (2014-03-31 18:43:51)


Daniel Santos

Offline

#6 2014-04-24 18:07:58

vhubbard
Beta User
From: Dallas, TX
Registered: 2004-11-11
Posts: 220
Website

Re: Move cutter compensation value to leftmost position in Tool Manager

Our original request years ago was to put these in formatted fields similar to gage height, orientation and so on.

Offline

Board footer