VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2014-03-27 14:25:56
- Verifun
- Senior Member
- From: U.S.
- Registered: 2005-03-31
- Posts: 351
- Website
Move cutter compensation value to leftmost position in Tool Manager
Hi folks,
I'll ask my local support team to open an SCR for this:
Daniel Santos
Offline
#2 2014-03-27 15:16:40
- Tony
- Moderator
- From: Crewe, England
- Registered: 2007-02-20
- Posts: 181
- Website
Re: Move cutter compensation value to leftmost position in Tool Manager
Nice one, makes it easier to read
Tony
Offline
#3 2014-03-28 15:14:33
- Verifun
- Senior Member
- From: U.S.
- Registered: 2005-03-31
- Posts: 351
- Website
Re: Move cutter compensation value to leftmost position in Tool Manager
We have a SCR now: SCR #12283 -- Move cutter compensation value to leftmost position in Tool Manager
Daniel Santos
Offline
#4 2014-03-31 07:28:01
- Tony
- Moderator
- From: Crewe, England
- Registered: 2007-02-20
- Posts: 181
- Website
Re: Move cutter compensation value to leftmost position in Tool Manager
Cutter Comp values are now aligned to the left
Tony
Offline
#5 2014-03-31 18:43:41
- Verifun
- Senior Member
- From: U.S.
- Registered: 2005-03-31
- Posts: 351
- Website
Re: Move cutter compensation value to leftmost position in Tool Manager
Last edited by Verifun (2014-03-31 18:43:51)
Daniel Santos
Offline
#6 2014-04-24 18:07:58
- vhubbard
- Beta User
- From: Dallas, TX
- Registered: 2004-11-11
- Posts: 222
- Website
Re: Move cutter compensation value to leftmost position in Tool Manager
Our original request years ago was to put these in formatted fields similar to gage height, orientation and so on.
Offline