VERICUT Users' Forum

girishnilange

Senior Member

From: Bangalore, India

Registered: 2006-08-26

Posts: 23

Circular motion blocks with I,J,K or R values in Modal

Hi.
I am dealing with a particular NC program which has the I, J, K and R values (for circular motion) defined in a modal fashion. They are not posted repeatedly unless their values change (when interpolating a cirlce with a different radius).
I have managed to adjust the controller to simulate this in Vericut by setting up variables to store the I/J/K/R values and reuse them in blocks with circular motion without I/J/K/R codes in them.

I wanted to know is there is a easier setting available in Vericut for this?

Whether such blocks run on the actual machine is a different issue, with this question I am expecting to know how flexible Vericut can be in changing the controller.

Thanks in advance!

Best Regards
Girish

Tony

Moderator

From: Crewe, England

Registered: 2007-02-20

Posts: 181

Website

Re: Circular motion blocks with I,J,K or R values in Modal

The solution you have using the variables is correct, there is currently no easier setting available in Vericut

---

Tony