VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2013-12-17 00:40:52
- VC1248
- Member
- Registered: 2013-11-08
- Posts: 6
Tapping Collisions
Every time I run a tap simulation I get tapping collision alarms for the minor ID of the tap. Usually the collision amount is .0001" or less. I have reviewed the tool info and cannot find anything wrong. Am I doing something wrong?
Offline
#2 2013-12-18 08:45:25
- MustaphaC
- VERICUT Specialist
- From: Le Mans, France
- Registered: 2004-10-14
- Posts: 130
- Website
Re: Tapping Collisions
In File > Properties, check option "Model Export Cut Mode" and try again
Mustapha
Offline
#3 2013-12-19 00:47:55
- VC1248
- Member
- Registered: 2013-11-08
- Posts: 6
Re: Tapping Collisions
Thank you for the reply. That did not correct the problem. But, while I was in the properties tab I found "Minimum error volume". I set that to .001 and it corrected the problem. Thanks for pointing me to the right direction.
Offline
Pages: 1