VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

Pages: 1

#1 2013-04-14 21:15:30

Verifun
Senior Member
From: U.S.
Registered: 2005-03-31
Posts: 351
Website

Sinumerik FLIN & FNORM?

I was told sometime ago that Sinumerik FLIN & FNORM functions are not emulated by VERICUT...

However, I know CGTech put significant efforts in Siemens functions in the past 2/3 years... who knows they're available now...

These two functions are critical to turn milling operations as they have a huge impact on feedrate calculation and thus in the total cycle time calculation... Currently, our time estimates in VERICUT for operations using FLIN are totally wrong and unreliable...

FLIN_zps2b87907e.png

Does anybody know if these functions are available now? If not available, are there SPRs requesting this already?

Thanks in advance,

Daniel Santos

Offline

#2 2013-11-24 23:54:36

Verifun
Senior Member
From: U.S.
Registered: 2005-03-31
Posts: 351
Website

Re: Sinumerik FLIN & FNORM?

Now possible in 7.3

FLIN.png

I knew they would make it someday, but I admit I wasn't expecting it so soon.  tongue

Thanks again CGTech!

Daniel Santos

Offline

Pages: 1

Board footer