VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2010-10-26 18:33:50

mike d
Member
Registered: 2010-10-26
Posts: 15

process speed

Hello All -
I am just wondering how many of you are using OPTIPATH, and what system you are using it on.
I have some pretty good size files and the processing speed seems unbearably slow.

Thanks

Offline

#2 2010-11-01 10:04:49

paehv
Senior Member
From: Eindhoven, Netherlands
Registered: 2005-01-17
Posts: 160
Website

Re: process speed

We use it on DELL Precision T7400 WinXP 32-bit 4GB RAM
Processing speed is just a little slower than a normal simulation. I find it very acceptable. smile
I think the speed depends a lot on your cutting tolerance. We set it normally to 0.2 mm (Our parts are quit big 700 to 1700 mm) so setting it smaller is useless because the system will run out of memory. :cry:


Patrick Delisse
KMWE Aerospacehttps://www.kmwe.com
(Vericut V9.4.1, Siemens NX2206, Campost)

Offline

#3 2010-11-03 15:11:40

mike d
Member
Registered: 2010-10-26
Posts: 15

Re: process speed

thanks pat,
I have about a dell precsion t3400 with 2gb ram, i did adjust cut tolerances and that seemed to help a bit.
Its time to tell the boss we need an upgrade!


Mike

Offline

Board footer