VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2006-06-20 11:14:20
- Volkov
- Member
- From: St. Petersburg, Russia
- Registered: 2004-12-15
- Posts: 25
- Website
OpenGL problems
On switching to OpenGL mode at Machine view, VERICUT 6 is terminated.
The same problems was repeated periodically in Vericut 5.4.
I am sure the problem is in compatibility VERICUT-ATI Radeon graphic card.
Could someone advice how to repair it (adapter settings, drivers ...)?
I use Windows XP Service Pack 2, Radeon 9600 graphic adapter (RAM 128Mb) with Catalyst driver version 6.2
Thanks in advance.
Regards.
Igor
www.bee-pitron.com
Offline
#2 2006-06-20 21:12:02
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: OpenGL problems
For a brief discussion of graphics acceleration, see http://www.cgtech.com/graphic_tech.htm
Offline
#3 2006-06-22 11:17:16
- Volkov
- Member
- From: St. Petersburg, Russia
- Registered: 2004-12-15
- Posts: 25
- Website
Re: OpenGL problems
Thanks Serge,
I have applied the advice about tab "troubleshoot" that has a slider for controlling the level or amount of hardware acceleration.
It helps but speed was decreased.
Regards.
Igor
www.bee-pitron.com
Offline
#4 2006-11-27 17:16:18
- BillH
- VERICUT Specialist
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 146
- Website
Re: OpenGL problems
The solution to this problem may be posted in:
Offline
#5 2007-05-17 14:35:22
- BillH
- VERICUT Specialist
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 146
- Website
Re: OpenGL problems
We are currently working with ATI to resolve various customer-reported crashes that seem to be specific to ATI-equipped computers. Hopefully we will get to a solution soon.
Offline
Pages: 1