VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2006-06-20 11:14:20

Volkov
Member
From: St. Petersburg, Russia
Registered: 2004-12-15
Posts: 25
Website

OpenGL problems

On switching to OpenGL mode at Machine view, VERICUT 6 is terminated.
The same problems was repeated periodically in Vericut 5.4.

I am sure the problem is in compatibility VERICUT-ATI Radeon graphic card.

Could someone advice how to repair it (adapter settings, drivers ...)?
I use  Windows XP Service Pack 2, Radeon 9600 graphic adapter (RAM 128Mb) with Catalyst driver version 6.2
Thanks in advance.


Regards.
Igor
www.bee-pitron.com

Offline

#2 2006-06-20 21:12:02

SergeV
Senior Member
From: Irvine, CA
Registered: 2004-10-08
Posts: 507
Website

Re: OpenGL problems

For a brief discussion of graphics acceleration, see http://www.cgtech.com/graphic_tech.htm

Offline

#3 2006-06-22 11:17:16

Volkov
Member
From: St. Petersburg, Russia
Registered: 2004-12-15
Posts: 25
Website

Re: OpenGL problems

Thanks Serge,

I have applied the advice about tab "troubleshoot" that has a slider for controlling the level or amount of hardware acceleration.

It helps but speed was decreased.


Regards.
Igor
www.bee-pitron.com

Offline

#4 2006-11-27 17:16:18

BillH
VERICUT Specialist
From: Irvine, CA
Registered: 2004-10-08
Posts: 146
Website

Re: OpenGL problems

The solution to this problem may be posted in:

http://cgtech.com/forum/viewtopic.php?t=705

Offline

#5 2007-05-17 14:35:22

BillH
VERICUT Specialist
From: Irvine, CA
Registered: 2004-10-08
Posts: 146
Website

Re: OpenGL problems

We are currently working with ATI to resolve various customer-reported crashes that seem to be specific to ATI-equipped computers. Hopefully we will get to a solution soon.

Offline

Board footer