VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2006-08-17 16:33:33
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Problem with ATI X300 video card
ATI uses proprietary OpenGL drivers that don’t perform well with VERICUT.
Workaround:
Lowering the hardware acceleration allows VERICUT to work with OpenGL. In the graphic card settings, lower the Hardware acceleration below the mid point.
Offline
#2 2006-10-18 20:26:08
- ChrisL
- Member
- From: SoCal
- Registered: 2006-10-18
- Posts: 2
Re: Problem with ATI X300 video card
You say that ATI's drivers don't work well...do you have a known good brand and model that does work well?
Offline
#3 2006-10-18 20:53:15
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Problem with ATI X300 video card
We have seen some problems with the low-end ATI cards, the X300 mostly. Higher end card should perform correctly.
We have been successful with the Nvidia cards. The Quadro series are especially performant in a CAD/CAM environment.
Offline