VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to:

You are not logged in.

#1 2018-10-05 15:39:46

Senior Member
From: Fryeburg, Me.
Registered: 2011-07-17
Posts: 86


I am building a new machine that is very similar to our Nicolas Correa machines but I'm having trouble with it not moving to y position correctly. It's off by 12.2067". If I put that in the datum it works fine so what do I need to do to my machine?

I took our proven Nicolas Correa machine and just swapped out the model / stl's to make my new Tessen 42.

Any suggestions?


Board footer