VERICUT Users' Forum

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Are you using Center Line files, or G-code, for Optipath ?

Are you using C/L, or G-code, for Optipath ?

I am just starting on Optipath, and am looking for any productive feedback, on those who experienced advantages, or disadvantages, of either.

Thanks for your input.

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."

paehv

Senior Member

From: Eindhoven, Netherlands

Registered: 2005-01-17

Posts: 167

Website

Re: Are you using Center Line files, or G-code, for Optipath ?

We use only C/L files for optipath.
I noticed that when using G-code and esspecially with "Add more cuts" turned on, the some G-code settings carefully build up by the post are
scruwed up by optipath. However when you do this on the C/L file, and run this modified input trough the post, it somes out perfect.

---

Patrick Delisse
KMWE Aerospace -  https://www.kmwe.com
(Vericut V9.5, Siemens NX2206, Campost)