VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2006-01-10 12:48:28
- Kantha
- Senior Member
- From: Boston
- Registered: 2004-11-11
- Posts: 48
Automatically going to the line of code for the gouges
I would prefer to have an option to go to the line (NC code) that caused the gouge when I pick the line in the gouge report. Now I need to look at the line and note down the line number and go to tool path and enter the loine number to go to that line in the NC code.
Kantha
Offline
#2 2006-01-27 15:54:02
- DaveF
- Senior Member
- From: Valencia, CA
- Registered: 2005-08-20
- Posts: 304
Re: Automatically going to the line of code for the gouges
Mega Ditto !!!!!!!!!!!!!!
:wink:
Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."
Offline