VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

Pages: 1

#1 2005-12-15 16:54:40

tri
Member
From: MA
Registered: 2005-11-28
Posts: 17

G43, G44 dmc60t

Does any one know how to config G43, and G44 for Heidenhain dmc60t control file? MotionToolOffsetNeg and MotionToolOffsetPos doesn't seem to work. I also tried to use CutterCompShort, and CutterCompLong, and it's not working...

Thankz,

Offline

#2 2005-12-21 18:28:13

SergeV
Senior Member
From: Irvine, CA
Registered: 2004-10-08
Posts: 507
Website

Re: G43, G44 dmc60t

I assume you are talking about the Heidenhain Mill-Plus control.

Leave the macros MotionToolOffsetNeg and MotionToolOffsetPos like they were.

Setup > Control > Adv. Options; Events tab
Start Of Processing
Add/Modify
Macro name = MotionToolOffsetOnMotion
Override Value = 1
Add
OK

Give it a try and let us know if it works.

Best regards,

Serge

Offline

#3 2006-01-13 19:43:29

tri
Member
From: MA
Registered: 2005-11-28
Posts: 17

Re: G43, G44 dmc60t

Thanks SergeV...

Offline

Pages: 1

Board footer