VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2006-01-12 13:51:37
- blampman
- Member
- From: Milton, VT, USA
- Registered: 2005-03-30
- Posts: 14
tool number recognition
We have a machine that uses tool numbers with a deciaml point '.' in them (i.e. 2112.700). When I try to call the tool Vericut only sees the four digits before the decimal point. Does anyone know of a way to recognize the whole number for the toolcode call?
Offline
#2 2006-01-13 11:22:13
- MustaphaC
- VERICUT Specialist
- From: Le Mans, France
- Registered: 2004-10-14
- Posts: 130
- Website
Re: tool number recognition
Hi,
Try to change "Inch Format" and "Metric Format" of the "T" word in Setup > Control > Word Format...
Should be "4.3" for your example 2112.700, but if you remove complety the values then every format will be accepted.
Mustapha
Mustapha
Offline
Pages: 1