VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2005-12-09 15:55:13
- RHILVERS
- Member
- From: Milwaukee, WI
- Registered: 2005-08-03
- Posts: 2
G30 tool change position set up
I need help setting up a secondary home position (G30) for a Mazak FH6800 horizontal with a PC Fusion control. G28 works fine and signifies the machine home, but I need the simulation to be able to also read a G30 and send it to a different location (tool change position). Right now it reads the G30 and sends it to what seems to be the last given workpiece zero.
Thanks in advance for any input!
Ryan Hilvers
Sr. Manufacturing Engineer
Wacker Corporation
Menomonee Falls, WI
ryan.hilvers@am.wackergroup.com
Offline
#2 2005-12-09 21:25:42
- GavinP
- VERICUT Specialist
- From: UK
- Registered: 2004-10-14
- Posts: 58
- Website
Re: G30 tool change position set up
You may want to review this posting as believe it should get you going, if not shout.
Offline
Pages: 1