VERICUT Users' Forum

umesh

Member

From: India

Registered: 2005-11-10

Posts: 6

Machine co-ordinate setting

Hi,
     I have got a 3-axis component. I have verified the same in vericut(using g and m-codes). I have added a 3-axis vertical Milling machine.

I need to match the co-ordinate system of the component and machine.
whats that i have to do.

Because by default the component is getting placed else were and program runs elsewere.

Thanks and Regards

---

Umesh B N
TCS
Bangalore, India

Anonymous

Guest

Re: Machine co-ordinate setting

umesh

Did you try going to the component tree and reposition your component.
You could go and create a new or alter the one your using and then move your component .

hope this helps

Joey

SergeV

Senior Member

From: Irvine, CA

Registered: 2004-10-08

Posts: 507

Website

Re: Machine co-ordinate setting

Hello Umesh,

You have a part in VERICUT, you have the machine and you want to locate your NC Program origin.

Setup > G-Codes> Settings; Tables tab
Add/Modify
Table Name = Program Zero
Select From/To Locations
From:Component: Name = Tool
To: Component: Name = Stock
Pick the Arrow next to the Stock entry
Select the NC program zero on the stock