VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2025-10-29 18:15:21
- Vericut_McAtee
- Senior Member
- From: Fryeburg, Me.
- Registered: 2011-07-17
- Posts: 89
Capturing machine position to a variable for a fanuc lathe
I need a little guidance on capturing machine "z" position to a variable in a fanuc lathe
Offline