VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2023-01-19 06:05:38

ipriyadarsinirallabandi
Member
Registered: 2022-05-10
Posts: 7

Laser Shot Peening

Can anyone help me on how to build control file for simulation of Laser Shot Peening in Vericut.

In general, in the shot peening machine the edge of the part needs to be blasted will be selected through a G code like top or left or right or bottom. Then the axis in which the blast move will be un freezed by specifying the G code. So, just the coordinate where the blast has to move from the current position will be given in the NC program. Based on that laser will automatically detect the edge and peen the profile accordingly in the real machine.

The problem what i face here when i try to build the control is, on how to configure the controller to automatically detect and follow the profile of edge with the help of x coordinate value and without any Y coordinate to it.

Controller is, Fanuc 31ICNC

Thanks in advance.

Last edited by ipriyadarsinirallabandi (2023-01-19 06:36:24)

Offline

#2 2023-01-24 16:23:29

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 154
Website

Re: Laser Shot Peening

Interesting project, please contact your local CGTech Technical Support


Tony

Offline

#3 Today 10:24:12

ipriyadarsinirallabandi
Member
Registered: 2022-05-10
Posts: 7

Re: Laser Shot Peening

Thank You!!

Offline

Board footer