VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2021-08-19 18:29:29

zac
Senior Member
From: NY
Registered: 2007-05-19
Posts: 63

Refine Display..!

It would be nice to give the user ability to either manually refine any given view's display or set to auto where vericut will automatically refine all open views displays at any change in position of the stock. Many times when we try to align the view in a certain way - at every intermediate stock position vericut automatically pause for view regeneration, which is not needed as the user hasn't got to the end position of stock alignment where he is intending to look and see..., waste a lot of time when working on large parts..., smaller parts this is not an issue, but for large parts with lots of details the refine view is causing a lot of pain and time wasted. There is already a button which says 'Refine Display' all we need is a way to tell vericut when to refine the display and which views to refine... don't know if it is feasible but just a suggestion that would help the folks a lot. Thanks much for your kind help and attention to user's needs.

Best regards,
Zac.

Offline

#2 2021-08-20 14:38:49

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 120
Website

Re: Refine Display..!

You can already do this, the default is Auto refine.

Go to View > Resolution and change to Manual


Tony

Offline

#3 2021-08-20 17:43:34

zac
Senior Member
From: NY
Registered: 2007-05-19
Posts: 63

Re: Refine Display..!

Thank you very much. That was a great help.

Best regards,
Zac.

Offline

Board footer