VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2021-07-14 13:41:10

dkrabbe
Senior Member
From: São José dos Campos, Brazil
Registered: 2006-08-03
Posts: 24
Website

Tool Manager Option: Stop Unconditional

Hello all

I would like to suggest that, inside of a Tool Manager, for an specific Tool, to have a flag that we can enable "Stop Unconditional" with a message. Then, when the simulation does a Tool Change for this Specific Tool, simulation will stop and showing the message. The reason is because is very usual to NC Programmers to do the CAM in parallel with real cutter tools being developed. It will warm that, up to receive the final drawing approval from cutter tool engineering team, programmers will be remembered that final drawing is not approved yet and simulation maybe not match the reality.

I did already inside of Tool Change subroutine, but it not sounds smart....

Regards

Daniel


Thank you and best Regards from Brazil,

Daniel Krabbe
Embraer
São José dos Campos, Brazil

Offline

#2 2021-07-16 15:56:56

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 128
Website

Re: Tool Manager Option: Stop Unconditional

Hi Daniel,

You could add a comment for that tool in your post eg. (DEVELOPMENT TOOL)

Then set Vericut to Stop At > Text > Development Tool


Tony

Offline

Board footer