VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2021-07-14 12:54:40

dkrabbe
Senior Member
From: São José dos Campos, Brazil
Registered: 2006-08-03
Posts: 24
Website

Stop at: Machine Movement

Hello,

I would like to suggest an option that Machine Simulation stop at Machine Movement (nowadays we have Max Errors, Warnings etc etc). I am suggesting a feature like will run similar as when you close the feedrate at real machine, and the program/subrotine wiil run up when machine will move and it will wait for machine operator to open de dial of feedrate again

Of course that we may minimize the speed of simulation and return it more fast, but in the option that I am suggesting, you will press the Simulation Button and all subroutines will run again and will stop again at new machine movement

Regards

Daniel

Last edited by dkrabbe (2021-07-14 12:55:09)


Thank you and best Regards from Brazil,

Daniel Krabbe
Embraer
São José dos Campos, Brazil

Offline

#2 2021-07-16 15:58:33

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 128
Website

Re: Stop at: Machine Movement

Hi Daniel,

We have that already with Stop at Each Motion Block.


Tony

Offline

Board footer