VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2021-01-06 13:27:40

TLaPan
Member
Registered: 2021-01-05
Posts: 1

5th axis shifting

Attempting to get our trunnion running in 5 axis. Made a post put the offset from the top of the platen to the center of rotation, looks good in vericut but it is shifted once it is sent to the machine. Removed the offset in the post and sent it to the machine and it is correct at the machine but shifted in vericut. I moved the G code offset (G55 is what we run) in vericut and tried the non-shifted post  and it is shifted worse. I am using the hascnc machine control from the library.

Offline

#2 2021-02-23 16:38:54

tstretton
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 106
Website

Re: 5th axis shifting

Did you manage to get the simulation the same as the real machine?


Tony

Offline

Board footer