VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2020-06-11 14:16:30

KHicks
Member
Registered: 2019-02-15
Posts: 6

Hiding item in Vericut at a program stop

Hello All,

So new at this it hurts.

I have a milling program that I ran thru Vericut and very near the end my tool slams into a strap in the center of the part.

In the machine program there is a program stop to remove the strap.

In Vericut I set it to stop at the program stop and it does.

What I don't know how to do is make Vericut hide this strap at that point.

Any help would be awesome.

Thanks

Offline

Board footer