VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2020-04-28 22:20:16
- TRickett
- Member
- Registered: 2017-01-10
- Posts: 7
verifying toolpaths
Quick question, if I see something with a single toolpath while running vericut, but it is like my 3rd operation on a particular part, is there a way to make a change on the CAM side, repost the toolpath, and restart the vericut process from that toolpath instead of having to run on the previous operations leading up to that toolpath?
Thank you
Offline
#2 2020-04-30 15:25:47
- Tony
- Moderator
- From: Crewe, England
- Registered: 2007-02-20
- Posts: 181
- Website
Re: verifying toolpaths
Right click in the nc code where you want to start from and click the last option > Restart on selected line
This runs normally but without any simulation to the selected point, this may be your best option.
Tony
Offline
Pages: 1