VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com

You are not logged in.

#1 2018-04-16 19:14:02

BPettegrew
Member
Registered: 2018-03-22
Posts: 2

Climb vs. Conventional milling

I would like to see the option to check for climb or conventional milling.
It would be a nice option when mirroring a program to make an opposite.

Offline

#2 2018-04-26 17:44:58

Tony
Moderator
From: Crewe, England
Registered: 2007-02-20
Posts: 181
Website

Re: Climb vs. Conventional milling

Would a message in the logger be enough to say Climb Milling or Conventional Milling depending on direction?


Tony

Offline

Board footer