VERICUT Users' Forum

gringwald

Member

Registered: 2016-06-16

Posts: 2

cutting length

I need to know the cutting length of each single tool in my program. Means the distance when the tool moves in G1,G2 or G3

Does anybody know how to find that out with Vericut Ver. 8.1

MartyM

Member

Registered: 2017-05-08

Posts: 1

Re: cutting length

When the program is done print out a HTML of tools that were ran look at time it took to run and then divide programmed feed rate. The logger will tell you how long each individual tool runs then if you want you can record air time also then subtract that from total time will tell you how many feet or inches you cut with tool. Hope this helps you