VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2018-02-14 12:08:35
- paehv
- Senior Member
- From: Eindhoven, Netherlands
- Registered: 2005-01-17
- Posts: 167
- Website
Machine/Control tab, Machine Settings, Locations tab???
Where did the LOCATIONS tab on Machine/Control > Machine Settings go?
According to the documentation they still exist and are used to specify initial tool location, tool change location, etc...
Patrick Delisse
KMWE Aerospace - https://www.kmwe.com
(Vericut V9.5, Siemens NX2206, Campost)
Offline
#2 2018-02-15 11:32:01
- MKoňařík
- Beta User
- Registered: 2016-05-18
- Posts: 19
Re: Machine/Control tab, Machine Settings, Locations tab???
In version 8.1....
Project -> Offsets -> Locations
Offline
#3 2018-02-15 11:57:05
- paehv
- Senior Member
- From: Eindhoven, Netherlands
- Registered: 2005-01-17
- Posts: 167
- Website
Re: Machine/Control tab, Machine Settings, Locations tab???
Hmmm,
I wonder why this wasn't available on the ribbon.
Thanxs
Patrick Delisse
KMWE Aerospace - https://www.kmwe.com
(Vericut V9.5, Siemens NX2206, Campost)
Offline