VERICUT Users' Forum

ffcut

Member

Registered: 2009-11-04

Posts: 16

Opening NX Part Files with V7

Hi guys,

I'm trying to open NX Part files as design model but having the error "NXinterface.dll not found"
When i launch Vericut 7 from NX to Vericut interface and then in Vericut i can open part files without getting the error.
Do i need to have NX interface license?

Thanks
Cem

SergeV

Senior Member

From: Irvine, CA

Registered: 2004-10-08

Posts: 507

Website

Re: Opening NX Part Files with V7

Hello,

Please refer to this Forum post:
<!-- l --><a class="postlink-local" href="http://www.cgtech.com/forum/viewtopic.php?f=4&t=1369&start=0&st=0&sk=t&sd=a&hilit=NX">viewtopic.php?f=4&t=1369&start=0&st=0&sk=t&sd=a&hilit=NX</a><!-- l -->

DaneS

Member

Registered: 2016-08-26

Posts: 1

Re: Opening NX Part Files with V7

Can someone repost the link that SergeV posted?  I can't follow it, says I have a bad address

mcam

Beta User

From: Planet Earth

Registered: 2007-06-10

Posts: 81

Re: Opening NX Part Files with V7

http://www.cgtech.com/forum/viewtopic.php?id=1369

Here you go

---

New Zealand Vericut Reseller