VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2016-03-22 11:19:16
- oneyankfan1
- Member
- From: Wichita, Ks
- Registered: 2014-04-10
- Posts: 16
Reviewer Question
My reviewer file when plyed shows all my feed lines and rapid lines. How do I get rid of these?
"3 people can keep a secret if 2 are dead." - Benjamin Franklin
Offline
#2 2016-03-25 20:09:37
- Verifun
- Senior Member
- From: U.S.
- Registered: 2005-03-31
- Posts: 351
- Website
Re: Reviewer Question
Not possible I think.
I have an SCR open to allow Reviewer to clear toolpaths every tool change. It´s a mess and polluted.
These guys makes some dumb apps sometimes... and allow them to be dumb for a significant while...
Daniel Santos
Offline
#3 2016-03-31 17:08:45
- dugcyn
- Member
- From: washington
- Registered: 2006-08-16
- Posts: 10
Re: Reviewer Question
Line Display check box in upper left (on off). next to tool display (solid translucent)
Offline
#4 2016-04-13 11:53:07
- oneyankfan1
- Member
- From: Wichita, Ks
- Registered: 2014-04-10
- Posts: 16
Re: Reviewer Question
Thanks guys, I found it.
"3 people can keep a secret if 2 are dead." - Benjamin Franklin
Offline
#5 2016-04-14 16:17:58
- Vericut_McAtee
- Senior Member
- From: Fryeburg, Me.
- Registered: 2011-07-17
- Posts: 88
Re: Reviewer Question
Not possible I think.
I have an SCR open to allow Reviewer to clear toolpaths every tool change. It´s a mess and polluted.
These guys makes some dumb apps sometimes... and allow them to be dumb for a significant while...
Daniel Santos
That would be better if you could display just the current tools path and not all or nothing the way it is setup now. I hope tech is able to do this. Good idea once again from Daniel!
Offline
Pages: 1