VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2005-08-03 20:47:42
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Looking for CATIA V5 demo part
We are looking for a good CATIA V5 example part to demonstrate CATV5 to our customers.
4-5 axis part
1 or more operations
G-Code programs
VERICUT files if available.
you can send me a PM or email me at serge.viau@cgtech.com
Thank you in advance
Serge
Offline
#2 2005-09-16 16:17:00
- msweeney
- Member
- From: Indianapolis, IN
- Registered: 2005-07-26
- Posts: 5
Re: Looking for CATIA V5 demo part
What are you looking for most?
A cool / interesting looking part?
A good example of a mistake that was caught?
A complex cutting method part?
Mark
Offline
#3 2005-09-16 16:58:03
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Looking for CATIA V5 demo part
Hello Mark,
A cool / interesting looking part is always a benefit. Most of you can relate more to a difficult part than to a block with 2 holes.
I was NC programmer long enough to know how to make a mistake :wink:
Since VERICUT 6.0 will emphasize on multiple setups, we would like to have a job with multiple setups. It would also help us on the work that needs to be done to the new CATIA V5 interface.
Offline
Pages: 1