VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2005-08-12 05:53:46
- chaddy Summy
- Member
- From: Brisbane, OZ
- Registered: 2005-06-21
- Posts: 12
VCT models
Hi all... Any suggestions on how to translate the *.vct models into something usefull.. like a STL model?
Fanx
Offline
#2 2005-08-12 20:23:34
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: VCT models
The VCT was created to help move the cut stock between multiple operations. It is internal to VERICUT. The only way to transfer it to an STL is to use the Model Export module.
Offline
#3 2005-08-15 06:14:20
- chaddy Summy
- Member
- From: Brisbane, OZ
- Registered: 2005-06-21
- Posts: 12
Re: VCT models
ok thankyou Serge
Offline
#4 2005-08-15 17:35:53
- BillH
- VERICUT Specialist
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 146
- Website
Re: VCT models
We are working to output an STL model from the VERICUT cut stock model (the same internal model that creates the VCT). This is a lengthy development and the level of success and quality of results are still unknown. This capability will be in VERICUT 6.0 (assuming we succeed)
Bill
Offline
#5 2005-08-15 21:58:42
- chaddy Summy
- Member
- From: Brisbane, OZ
- Registered: 2005-06-21
- Posts: 12
Re: VCT models
Hi Bill...
Vericut 6? wow! sounds like a long while away...?
I hope you succeed
Offline
#6 2005-08-15 22:24:29
- BillH
- VERICUT Specialist
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 146
- Website
Re: VCT models
Actually, 6.0 is the next release. We're shooting for end of this year.
Bill
Offline
Pages: 1