VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2014-07-25 13:49:43
- tomste1228
- Member
- Registered: 2014-07-25
- Posts: 1
Cutter compensation not being activated in simulation
Just started using vericut for the first time.
Started simulating my job, and when it comes to a tool that has cutter compesation applied, vericut doesnt seem to be applying the cutter comp in the simulation, the tool is continuing to cut on the centerline of tool. This then cause a collison that wouldnt actually happen.
Any idea on how to sort this out.
Thanks
Tom
Offline
#2 2014-07-25 14:01:57
- Tony
- Moderator
- From: Crewe, England
- Registered: 2007-02-20
- Posts: 181
- Website
Re: Cutter compensation not being activated in simulation
Click on the Setup in the Project Tree, then at the bottom of the Project Tree there should be two tabs. Click on theG-Code tab and where it says Process Cutter Comp change the pulldown to On - Default to Full Radius.
If this doesn't work speak to your local CGTech Tech Support guy.
Tony
Offline
#3 2015-06-11 01:05:05
- Jsmith
- Member
- Registered: 2015-05-05
- Posts: 1
Re: Cutter compensation not being activated in simulation
That worked for me also!
Offline