VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2005-05-31 22:36:22
- EngMfg1
- Member
- From: Calif.
- Registered: 2005-05-31
- Posts: 13
tool change
I am using the ganaric fan15m.ctl
I’ve tried using Setup>Control>ADV.Options>substitute like this but the machine is not I the right position when it reads the H01
input text output text
H01 T1M6
N104T01
N105T02
N106G90
N107S191M03
N108G54
N109G0G90G43Z10.88H01 < I want the tool to appear in vericut when it reads is line
Offline
#2 2005-07-12 17:12:28
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: tool change
Setup > Control > Word Address > Registers
H *, * *
Add the macros: ToolCode and ToolChange
This way, when it sees H01, it will select tool #1 and change it.
VERICUT will ignore the T numbers and will change the tool based only on the H number.
Offline
#3 2005-07-12 17:41:51
- EngMfg1
- Member
- From: Calif.
- Registered: 2005-05-31
- Posts: 13
Re: tool change
Thank I appreciate your help 
Offline
Pages: 1