Can Vericut check for small circulair segments?

paehv · 2014-06-20 11:08:28

Does anyone know if it's possible to have Vericut check for a circulair record (G2/G3) "if the end point is closer to the current point than a specified value"?

I need to check if the endpoint of a circle motion is closer than 0.02 to the current position and give an error if so.

MustaphaC · 2014-06-23 11:59:53

If you define the Calculation Tolerance under Control Setting bigger than the value you want to detect you will get the following warning:
"ignoring circle statement with zero radius"
Not sure if that is what you are looking for?

paehv · 2014-06-23 13:11:29

Yes, that would be good enough. Thanks

VERICUT Users' Forum

#1 2014-06-20 11:08:28

Can Vericut check for small circulair segments?

#2 2014-06-23 11:59:53

Re: Can Vericut check for small circulair segments?

#3 2014-06-23 13:11:29

Re: Can Vericut check for small circulair segments?

Board footer