VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2014-02-13 19:28:46
- Deacro
- Member
- Registered: 2013-05-30
- Posts: 1
Wear and control
I am using wear and control compensation on the same part. When I vericut the wear is showing gouge.
Offline
#2 2014-02-14 01:49:00
- cginther
- Member
- Registered: 2010-06-19
- Posts: 19
Re: Wear and control
What does the code look like. You may need to make it not process the wear comp in order to cut straight.
Offline
#3 2014-03-06 21:57:14
- Verifun
- Senior Member
- From: U.S.
- Registered: 2005-03-31
- Posts: 351
- Website
Re: Wear and control
Not sure if I'm saying something wrong here but I think you can't have both ways in the same program..
Daniel Santos
Offline
#4 2014-03-11 03:24:13
- Verifun
- Senior Member
- From: U.S.
- Registered: 2005-03-31
- Posts: 351
- Website
Re: Wear and control
Well, one way to have this in the same program is altering the tool radius via program...
Changing to wear in a tool defined to work with control in Heidenhain:
TOOL CALL xxxx DR-y.yyy where y.yyy is the real radius of the tool with a negative signal...
All modern controls (2000-Present) will allow you to do this..
Last edited by Verifun (2014-03-11 03:25:04)
Daniel Santos
Offline
Pages: 1