VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2005-05-05 14:49:33
- Joeyls319
- Member
- From: Horseheads n.y.
- Registered: 2004-12-18
- Posts: 40
error b axis lock message
Morning everyone,
Well I created my first 5th axis machine today. I went to run a program and I got the following error message. ERROR B AXIS LOCK. Not sure what it means. :? I'm sure I didn't do something right and or didn't hit a switch or something. If anyone has any suggestions please let me know.
Thanks,
Joey
Learn something new everyday.
Offline
#2 2005-05-05 20:21:42
- GavinP
- VERICUT Specialist
- From: UK
- Registered: 2004-10-14
- Posts: 58
- Website
Re: error b axis lock message
Under Setup, Control, Word Address, Registers B what appears ?
Did you add some configuration to catch motions when the axis clamps are on ? This is a common modification.
Offline
#3 2005-05-05 20:38:22
- Joeyls319
- Member
- From: Horseheads n.y.
- Registered: 2004-12-18
- Posts: 40
Re: error b axis lock message
It also said that m13 is not defined, that may have something to do with it.
M13 is 5th axis release brake.
I'll try defining that and see what happens.
Thanks Gavin.
Joey
Learn something new everyday.
Offline
Pages: 1