VERICUT Users' Forum

Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to:

You are not logged in.

#1 2012-07-19 22:02:08

Registered: 2010-05-27
Posts: 11

ProeV - DO not Regenerate all Operations Everytime

The ProeV interface always regenerate all ProE tool paths, even when the NC source is set to G-Code   8) , that means you already regenerated everything, created the CL and then already post processed.

So the suggestion is a quite simple, doesn't regenerate the entire operations if G-Code option is checked, just send the models and stuff to Vericut is more than sufficient once you are supposed to had did it already.

NC Programer - CAV Support - Software Developer
GE Oil and Gas Brazil


Board footer