VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
#1 2012-05-22 09:06:38
- SK_MTU
- Beta User
- Registered: 2010-04-13
- Posts: 3
Laser tooling (laser drilling)
We´re using lot of lasermachines Deckel Maho/Sauer LaserTec.
There is no direct way to use laserbeam as a tool (drilling/shaping...).
Maybe it´s possible to attach a laser tool like the water jet cutting tool (diameter, angle aso.).
Offline
#2 2012-06-27 18:07:28
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Laser tooling (laser drilling)
our customers simulating the Laser machines use the water jet tool. Just like the water jet, the laser has a focus area, if you are too far or too close VERICUT will give you an error.
Offline
#3 2012-07-23 12:29:13
- SK_MTU
- Beta User
- Registered: 2010-04-13
- Posts: 3
Re: Laser tooling (laser drilling)
ok, i had several Problems with the Waterjet :?
So i tinkered a bit and created a special laser milling tool
but maybe it is possible for the future releases to build a special laser tool :wink:
Offline