VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2012-05-19 11:06:51
- JDoran
- Member
- Registered: 2012-03-27
- Posts: 3
Mazak 640mpro
Wondering if anyone has a good 640mpro controller for an e410 horizontal series integrex - or advice on how to get the one I have to work correctly with G68 (coordinates rotation).
Thanks
Offline
#2 2012-07-23 13:06:48
- SergeV
- Senior Member
- From: Irvine, CA
- Registered: 2004-10-08
- Posts: 507
- Website
Re: Mazak 640mpro
in the Library: mazatrol_matrix_integrex_e.ctl
it is configured for the G68, it will be a good start point.
Offline
#3 2012-07-25 03:44:07
- cginther
- Member
- Registered: 2010-06-19
- Posts: 19
Re: Mazak 640mpro
If you have tech support, ask them to help you get it right! If you open one and it works or if you don't figure it out there is nothing learned. I have an e420 with a matrix control and it is not too difficult if you know how vericut works. There are a lot of controls that have G68 setup correctly. If the mpro is like the matrix it is a fanuc style and most fanuc controls should be setup correctly.
Good luck, remember a solution without learning is not a success!
Offline
#4 2012-07-25 03:45:21
- cginther
- Member
- Registered: 2010-06-19
- Posts: 19
Re: Mazak 640mpro
If you have tech support, ask them to help you get it right! If you open one and it works or if you don't figure it out there is nothing learned. I have an e420 with a matrix control and it is not too difficult if you know how vericut works. There are a lot of controls that have G68 setup correctly. If the mpro is like the matrix it is a fanuc style and most fanuc controls should be setup correctly.
Good luck, remember a solution without learning is not a success!
Offline
Pages: 1