VERICUT Users' Forum

Chigishev

Beta User

From: Moscow, RUSSIA

Registered: 2008-10-21

Posts: 51

Website

ORICURVE DUAL SPLINE (SINUMERIK)

Hello!
I have a very difficult question....
HOW I CAN simulate ORICURVE and DUAL Spline (one - for tool tip and second spline - to point on  too axis)?
I can see this motion in SINUTRAINE (poor quality of material removing) - see video http://www.youtube.com/watch?v=nmcoB1dbzm4.

NC PROGRAMM IS:

G1.....
ORICURVE
SPLINEPATH(1,X,Y,Z)
BSPLINE SD=2
X=... Y=... Z=.... XH=... YH=... ZH=...

Any ideas - HOW I CAN SIMULATE similar motion in VERICUT??? Of course, I can move tool in VERICUT from point to point - but I dont know any law for spline motion in SIEMENS...

Thank you

---

http://www.postprocessor.ru