VERICUT Users' Forum
You are not logged in.
- Topics: Active | Unanswered
#1 2011-05-23 21:08:50
- jsmillett
- Member
- From: Chatsworth, CA
- Registered: 2005-02-25
- Posts: 42
Fast Feed rate in Motion Dialog Box
In Vericut V6.2.2 I can set the Fast Feed rate in this dialog box:
Menu -> Project -> Processing Options -> Motion
Where do I find it in V7.1.x?????????????????????????
Thanks
Jerry Millett
Offline
#2 2011-05-24 10:56:21
- MIKEFITZ
- Member
- From: Chicopee, MA
- Registered: 2009-06-18
- Posts: 104
Re: Fast Feed rate in Motion Dialog Box
In the Project Tree, click on Setup: 1. On the bottom of the tree, click on the Motion tab. The first tab is your fast feed setting.
Note: If the tabs do not show up at the bottom of the Project Tree when you click on Setup: 1, make sure the button at the top of the Project Tree is toggled on. It is the one to the left of the Machine Configuration button, looks like a list with a hand on it.
Hope this helps!
-Mike
Mike
Hoppe Tool
Offline
#3 2011-05-24 18:04:10
- jsmillett
- Member
- From: Chatsworth, CA
- Registered: 2005-02-25
- Posts: 42
Re: Fast Feed rate in Motion Dialog Box
Thanks Mike. That's what I was looking for. I'm getting too old to relearn all this stuff!
Jerry
Jerry Millett
Offline