You are not logged in.
Pages: 1
Good morning all,
I am setting Vericut for Haas_vr11 5axis this machine using G143 with tool tip control, every thing
look good for 3axis , but when do the pocket with 5axis motions the pocket came
out so small, so I added the RTCP offset in the Machine Setting, Location (0 0 11.571)some how did not work,
Do I miss something could some one help me out?
Thanks
DNguyen
Offline
Hi There DNguyen,
It would be better to contact your local CGTech support Office with the files attached via Copy all method.
If you add a description of the issue I am sure they can help you a lot quicker than here on the Forum.
Best Regards
GavinB
Offline
Pages: 1