VERICUT Users' Forum
Due to relentless spammers, we are no longer automatically accepting new forum registrations. If you wish to register for this forum, please send an e-mail to: info@cgtech.com
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2011-05-13 13:13:31
- DNGUYEN1
- Member
- From: KS
- Registered: 2005-06-16
- Posts: 32
Haas VR11
Hello all,
I am setting the Vericut for 5axis vertical machine, Haas VR11 this machine Using the G143 for tool tip control it same with fanuc control (G43.1), but for some reasons the Haas .ctl file did not recognize the G143 (tool tip)
I used MDI to tested it key in G143 H1 Z0. instead machine calculated the tool tip, but it not it calculated by Center line of A axis and the whole spindle hit
machine table.
Please help Thanks
Dnguyen
Offline
#2 2011-05-27 03:32:57
- MichaelS
- Senior Member
- From: Lynnwood, WA
- Registered: 2011-02-01
- Posts: 28
- Website
Re: Haas VR11
I would check the Gage Lengths of your tools in Tool Manager and your Work Offsets in the tree.
Michael Stevenson
Vericut Programmer
PCC Aerostructures
Offline
Pages: 1