VERICUT Users' Forum

paehv

Senior Member

From: Eindhoven, Netherlands

Registered: 2005-01-17

Posts: 166

Website

Multiple "STOP AT" options

It would be nice if you could set multiple STOP AT options.
Now you can choose one of the nine options at witch you want to stop simulation.
It would be very usefull if you could specify -for instance- Stop at End of each setup AND Toolchange
Perhaps an idea to be able to specify this per setup?

---

Patrick Delisse
KMWE Aerospace -  https://www.kmwe.com
(Vericut V9.5, Siemens NX2206, Campost)

Svante

Senior Member

From: Trollhättan, Sweden

Registered: 2005-02-23

Posts: 60

Re: Multiple "STOP AT" options

Multiple STOP AT-options would be a very useful improvement.

---

Svante Eriksson
System owner
GKN Aerospace Engine Systems Sweden
Vericut 7.2.1, 7.3.4, 7.4 - NX 9.0.3

DaveF

Senior Member

From: Valencia, CA

Registered: 2005-08-20

Posts: 304

Re: Multiple "STOP AT" options

Good Idea...

I actually submitted an enhancment request for this, a long time ago, in a galexey.... right here on earth.

Lets hope in makes it into the next version of Vericut.

Best Regards,
Dave

---

Dave Frank
Aerospace Dynamics International, PCC
Valencia Ca
"Where else can you have this much fun,.......and get paid???."

Verifun

Senior Member

From: U.S.

Registered: 2005-03-31

Posts: 351

Website

Re: Multiple "STOP AT" options

Totally agreed on this one...

What if CGTech could add a "+" "-" buttons so that the user can add or remove as many custom "STOP AT" cmds as he wants...

JM2C

---

Daniel Santos